|TheSenpai Series of non-isolated dc-dc converters deliver exceptional electrical
and thermal performance in industry-standard footprints for Point-of-Load
Operating from a 20.4Vdc-27.6Vdc input, these are the converters of choice for Industrial and networking applications that require high efficiency, tight regulation, and high reliability in elevated temperature environments with low airflow.
The FPMR24SN2R502PA converter of the Senpai Series delivers 2.5A of output current at a tightly regulated programmable output voltage of -7.5Vdc to -2.5Vdc.
The thermal performance of the FPMR24SN2R502PA is best-in-class: No derating is needed up to 85℃, under natural convection.
This leading edge thermal performance results from electrical, thermal and packaging design that is optimized for high density circuit card conditions.
Extremely high quality and reliability are achieved through advanced circuit and thermal design techniques and FDK’s state of the art in-house manufacturing processes and systems.
Get Data-Sheet Click Here ! (PDF)
Delivers up to 2.5A(18.75W)
High efficiency, no heatsink required
No derating up to 85℃
Positive ON/OFF logic
Industry-standard SMD footprint
Small size and low profile: 0.80" x 0.45" x 0.211" nominal
Coplanarity less than 0.004"
Tape & reel packaging
Programmable output voltage via external resistor
No minimum load required
Start up into pre-biased output
Power good signal
Auto-reset output over-current protection
Auto-reset over-temperature protection
High reliability, MTBF = TBD Million Hours
UL60950 recognition in U.S. & Canada, and CB Scheme certification per IEC/EN60950 (Pending)
All materials meet UL94, V-0 flammability rating